Cable Signal Leakage Detector

Cable signal leakage can interfere with any of the over the air services using the same frequencies as the cable operator within the vicinity of the cable system.

Cable signal leakage detector.

Using a dedicated leakage detector typically with a built in antenna orient the detector and its antenna to get a maximum reading and see. Cable operators for decades have dealt with the monitoring and measurement of signal leakage field strength. Contact us at 972 907 8100 in richardson tx for our rf detector services to find the signal leakage in your cable cable. Cable signal leakage cable signal leakage sometimes called egress occurs when rf signals leak out from the cable plant and spread into the environment.

As it turns out comcast had detected some sort of signal leakage inside my home that was caused by unused open cable outlets. Given this constraint a signal leak from one location can potentially mask a leak from a nearby location. In the home coaxial network signal levels are lower than outside plant levels and the migration to all digital services means even greater sensitivity is needed in a leak detector. About 25 years or so ago a cable tech stopped by my parents house saying that there was cable signal leakage.

Historically signal leakage detectors have required high levels of sensitivity to measure signal leakage radiating from the catv system. Cable signal leaks can be caused by loose connectors damaged plant cables or cracked or unterminated cables. Cable leakage technologies 1211 executive drive e richardson tx 75081. After a fairly quick inspection he found a place where the cable was stapled to a floor joist too tightly compressing the cable which changes the properties of the shielding and causes it to radiate signal.

Signal leaks can also be intermittent meaning a slight bend or movement in the cable from one point in time. But just what is field strength. And egress or leakage is an open. They sent somebody over to put a filter on the pole outside to keep.

The signal cable should be terminated between the sensor and the main alarm bms in the following manner. The measurement of signal leakage is fairly straightforward. Cable operators are considered secondary users of these frequencies.